glass 1989 pop 140, Руководство по эксплуатации и обслуживанию

Страница: 29 / 92

11
EN
AIRPOOL FUNCTION
(only if available on the model)
To start the airpool function, push the
button (4). The “airpool system functioning”
led will light up.to stop the airpool function
before the end of the set time, push again
the same button.
“flashing led” indicates water missing; fill
further the bathtub, over the level of the
jets. if there is no water, the airpool does
not work.
WARNING: the Blowing After works
only when the bathtub is empty. Do
not use the bathtub during the cycle.
Drain the bathtub completely at the end
of the cycle.
To start the “blowing after”, push the button
(4). The “airpool system functioning” led
starts flashing, to confirm the start-up of
the function, push again the button at the
third flash.
CHROMOTHERAPY
(only if available on the model)
WARNING: When CHROMOTHERAPY
is present, the function LED ALWAYS
remains on.
To start the Chromotherapy function, just
press the button (3); the preset duration is
approximately 60 minutes. The first time
the button is pressed the preset cycle is
switched on. The required colour may be
selected during the cycle by pressing the
button (3) again.
Just press the same key again to turn off
the chromotherapy.
CHROMOTHERAPY
1. CHROMOTHERAPY ON/OFF light/
button.
To start the Chromotherapy function, just
press the button (1); the preset duration is
approximately 60 minutes. The first time
the button is pressed the preset cycle is
switched on. The required colour may be
selected during the cycle by pressing the
button (1) again.
To switch off the chromotherapy, just keep
the button (1) pressed down.