COMBO IS A TRADEMARK OF GLASDON GROUP AND ITS SUBSIDIARIES IN
THE U.K. AND OTHER COUNTRIES.
Replacement components are available direct from GLASDON.
GLASDON cannot be held responsible for claims arising from incorrect installation, unauthorised modifications or misuse of
the product.
Issue 1
February 2012
C000 /0420
© Copyright 2011
Glasdon U.K. Ltd reserves the right to alter specifications without prior notice.
Preston New Road
BLACKPOOL
Lancashire FY4 4UL
Tel: 01253 600410
Fax: 01253 792558
E-mail: [email protected]
Web: www.glasdon.com
P. 2
Cleaning
We would recommend a warm pressure wash with soap or alternatively hand wash with 10%
solution of mild detergent in warm water using a soft bristle brush followed by a rinse with clean
water.
Graffiti
Felt tip pen or paint may be removed from Durapol
using Glasdon Grafitix Graffiti wipes or other
proprietary graffiti remover. Carefully follow the instructions, particularly the guidelines covering
safety. Ensure that all traces of chemicals are removed then clean as detailed above. Please be
aware that graffiti removers can damage signs and personalisation stickers etc. Protect these areas
when using graffiti removers.
Maintenance
A planned maintenance schedule of regular inspection is recommended and components
replaced when necessary.
CLEANING AND MAINTENANCE:
TM
GROUND FIXING:
TM
Fig 6.
KIT CONTENTS:
ITEM 1 TLM Fixing Bolts
x4
ITEM 2 37mm Plastic Spacers
x2
ITEM 3 M10 x 50mm Washers
x2
TOOLS REQUIRED:
Hammer
17mm Spanner and Socket Head
Electric Drill
10mm Masonry Drill Bit
Marker Pen
1. Remove the two black hole plugs at the front inside base of the
unit.
2. Using the fixing holes as a guide, mark on the ground where the
ground fixing bolts will go.
3. Drill the four holes marked to a depth of 55mm using a 10mm
masonry drill.
4. Remove the nut from the fixing bolts (Item 1) and slide on the
plastic spacers (Item 2) followed by an ]m10 washer (Item 3).
5. Using the hammer insert the two rear fixing bolts into the
ground leaving 65mm protruding above ground. Fig 6.
6. Slide the bin backwards onto the fixing bolts ensuring the bolts
are located within the fixing recesses. Fig 7.
7. Insert the remaining fixing bolts through the front of the unit.
8. Fully tighten all bolts using the supplied nuts until the bin is
securely fixed. Fig 8 and 9.
Fig 7.
Fig 8.
Fig 9.
