Sensor Slew & Height (Multi)
Quick Start Guide
Key Switch Positions
M2000010 V1.1
Operational
Turn the key switch to the straight position.
This puts the system into the Operational Mode. While in this
mode, both Slew and Height Limits are active.
Service Menu or Calibration Mode
Turn the key switch to the right position to access Override, Set
Limits and Service Area.
From this menu, both Slew and Height limits can be set and/or
adjusted. Also, the system can be overridden if required.
The Service Area is passcode protected.
Travel Mode
Turn the key switch to the left position to enable Travel Mode.
While in Travel Mode, both Slew and Boom controls are locked, but
travel is allowed (depending on optional Travel Inhibit valve).
F1
F3
F2
F4
OK
Sensor Slew & Height monitors the slew position of the machine by
means of counting of the slew teeth and also monitors the position
of the front end equipment (Boom and Dipper) to allow the safe use
of the machine while under obstacles.
This quick start guide takes you through setting both Slew and
Height limits as well as the operational mode of the system.
It also covers the Safety Check procedure for checking the slew
motion cut valves.
When the system powers up, and displays the GKD logo, press the
OK
button to enter the operational mode.
Arrow Keys
