Gira 2105 02, Руководство по эксплуатации, Страница: 3 / 10

4 Operation
Only for "Comfort" version:
Function buttons IR remote control
Button Function
¿ Detection of a motion is sent for function block
1. The automatic mode is exited.
Á End of a motion is sent for function block 1.
The automatic mode is exited.
À The automatic mode is activated again for
function block 1.
The ON state is first exited after a new motion
detection.
Adjustable buttons IR remote control
Button Function
´ Increasing sensitivity
² Reducing sensitivity
³ Resetting sensitivity to presetting
Ê Function block 1: Brightness threshold 10 lx
Ë Function block 1: Brightness threshold 50 lx
Ì Function block 1: Brightness threshold 150 lx
Í Function block 1: Brightness independent
operation
É Function block 1: Set current brightness as
brightness threshold
¼ , Ï , Ð , Ñ ,
Ò
Function block 1: Extend minimum run-on-time
(10 seconds) by the selected value
Ó , Ô Function block 1: Extend minimum run-on-time
(10 seconds) individually
Set-up buttons of IR remote control
Button Function
Ù Walking test – Check detection field
Ú Reset sensitivity, brightness threshold and
run-on-time to presetting. Press for at least 3
seconds
Operation with IR remote control
If enabled, function block 1 can be operated manually by remote control. In manual operation,
brightness and motion detection for function block 1 are switched off until automatic mode is
reset.
o Switch on, e.g. light: Press ¿ button.
o Switch off, e.g. light: Press Á button.
o Set automatic mode: Press À button.
82585602 20.09.2012
3/10
KNX/EIB
Presence detector