6
Inserting slats
Using the optionally available slats, the lighting
element of the energy profile can be used for
targeted object or path illumination.
To use the slat element and the accompanying
transparent plate, proceed as follows:
1. Loosen both cover screws and remove the
profile cover.
2. Pull the diffusing plate upward from the
guide.
3. Insert the transparent plate from above
(please note the "TOP FRONT" labelling).
4. Insert the slat element:
Slats directed upward,
e.g. for object illumination.
Slats directed downward,
e.g. for path illumination.
5. Set the profile cover in place and fasten it
with both cover screws.
Technical data
Dimensions (W x H x D)
Profile base:
229 x 10 x 155 mm
Profile:
142 x 491 x 75 mm or
142 x 769 x 75 mm
Protection type:
IP 44 with closed
device covers
Connections:
terminal screws 1 x 4 mm
2
or 2 x 2.5 mm
2
Lamp:
Light sources with E27
treading of the energy
efficiency classes A++ to E
Power: 21
W
max.
Diameter:
52 mm max.
48 mm max.
(if slats element is used)
Lit area
Energy profile with lighting element, height
769 mm, frosted diffusing plate, 20 W
Hight of point of light above ground: 0,65 m
i
Transparent plate/diffusing plate
The slat element can be used with either the
transparent plate or the frosted diffusing plate.
