Page 10
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
2.0 Installation
2.3 Electrical Connection
2.3.1 Information
Three Phase Units:
• A terminal block for on-site connection, by a licensed electrician located inside the service compartment of the unit, indicated as:
- 3Ø + N + E
This unit must be installed in accordance with AS/NZS 60335.1
Some procedures in this manual require the power to the equipment to be turned off and isolated.
Turn the power OFF at the power point and unplug the power supply lead by the plug body. If the
power point is not readily accessible turn the equipment off at the isolation switch or the circuit
breaker in the switchboard. Attach a yellow “CAUTION-DO NOT OPERATE” tag. This must be
performed where relevant unless the procedures specify otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
WARNING
Single Phase GAS Units:
• Supplied and fi tted with an appropriately rated plug and lead
Notes:
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a
hazard. Please contact Stoddart for parts and we will advise how to do this in order to avoid any electrical hazard
• The power cable should be dry and/or isolated from moisture or water
