Giltrap WideTrac, Руководство по эксплуатации и запасным частям, Страница: 21 / 46

Page 21
WideTrac Operation & Parts Manual
Remote Control Key Fob
The spreader remote is used to power off & on and start & stop spreading from the
tractor cab.
Press the (ON/SPREAD) button to power on the spreader controller.
If spreading parameters (product density, spread width, and spread rate) are already
correct, press the (ON/SPREAD) button to start spreading.
The controller will not start the belt until a ground speed is detected.
If the door is closed and the top button is pressed to start spreading, the LED will be
RED while the door moves into position
and the “Door Opening” message will show on-
screen. The LEDs will turn GREEN
and screen will say “Ready to Spread” once door
moves to correct height.
To stop spreading, press the bottom (OFF/PAUSE) button. This will stop the belt moving
and door will remain at the height it was when button was pressed.
To power off and close the spreader door, press and hold the (OFF/PAUSE) button until
the screen says “DOOR CLOSING”.
The remote uses 1 X 12V A23 battery.