Rev: 07/05/2016
Heating Adapter Kit for MA-52X 5qt Mixers
MAA-28
PHONE: 800-444-1508
P.O. Box 200, Lewis Center, Ohio 43035-0200
FAX: 800-255-5314
740-548-7298
E-mail: [email protected] Website: www.globalgilson.com
740-548-5314
OPERATING MANUAL
FEATURES:
The MAA-29 Heating Adapter Kit includes:
• 250 Watt heating mantle appropriately 1in thick, 8in inside
diameter and 3in deep. Supplied with electrical lead and
Velcro straps.
• Controller for the heater mantle with 0—100% proportional
heating scale, 12 amp Buss type fuse, heat-on indicator
light and power cord.
• Connecting cord connects heating mantle to controller.
• Pedestal Spacer Kit with drilled metal spacer block and
four 2in long 5/16-18 Hex Bolts.
If any parts are missing or damaged, contact delivering carrier
and Gilson Customer Service immediately.
ASSEMBLY INSTRUCTIONS:
A. Installation of the Pedestal Spacer:
1. Turn mixer power switch <OFF> and disconnect power
cord from wall receptacle.
2. Remove the bowl and beater.
3. Lay the mixer down on the opposite side from the control
panel, or turn completely upside down. If put on its side,
the pedestal arm must be supported to hold the bowl height
adjustment lever off the table top. If turned upside down,
the pedestal arm must be clamped to stabilize the mixer
during installation of the pedestal spacer.
4. Remove the four Phillips machine screws connecting the
pedestal base to the pedestal spacer.
5. Remove and set aside the screen.
MAA-28
(Continued on back.)
6. Set the pedestal base aside.
7. Determine top-bottom orientation of the metal spacer
block by matching the pedestal arm contour. The four bolt
holes on the spacer are evenly spaced. The spacer must
be oriented correctly front to back.
8. Align the four holes on the spacer block with the four holes
on the pedestal arm. Next, align the pedestal base over
the four holes of the spacer bottom. Then align the screen
over the bottom of the pedestal base. Place a bolt in each
of the four holes and tighten with a socket wrench.
9. Sit mixer upright on table, install paddle and bowl, plug
mixer back into wall receptacle and test operation of mixer
to ensure spacer is secure and properly installed. Operate
mixer in accordance with manufacturers instructions.
NOTE: Modified mixers may no longer qualify for
applications involving food, cosmetics or pharmaceuticals.
Check with all applicable agencies and codes before
using a modified mixer for these purposes.
