O
p
E
R
A
TIO
N
7
CENTRY™ 103 MINICENTRIFUGE
|
USER’S GUIDE
Installing the Rotor
NOTE
Before the initial use, turn the rotor slowly by hand, five to six revolutions.
1.
Install the rotor
8
or
9
onto the motor shaft boss
3
.
2. Push down until it clicks. (Refer to Figure 2.) Make sure that the tabs of the boss are blocked
inside the hole of the rotor.
For dismounting the rotor, hold it by both hands and push the tabs inward with two thumbs
to disconnect them from the rotor, and then pull the rotor out from the motor shaft boss.
WARNING
Do not use any damaged, deformed, or corroded rotors. It may break the rotor while
spinning and cause unexpected accidents or injury.
Figure 4
Balanced rotor with
2 tube-strips
Figure 3
Balanced sample microtubes setting
Figure 2
Install the rotor onto the motor shaft boss
3
8
9
