GILLIG LOW FLOOR, Руководство по обслуживанию

Страница: 100 / 506

Engine
00
Figure 3-16, Engine Dolly
Engine Dolly
The engine dolly (Figure 3-16 ) is used to remove or install the engine/transmission. The dolly used for
this task must be capable of supporting the engine and transmission combination used on the coach. The
proper dolly can be ordered through the Gillig Corporation.
Operation Instructions
Do not use a dolly that is not designed for the specific engine installed
in the coach.
If using the Gillig engine dolly, the engine and transmission MUST be
removed as an assembly. It is not possible to remove either component
separately with the Gillig dolly without the high probability of sustaining
damage to the equipment or possible injury to personnel.
If the engine/transmission assembly is left on the dolly, the upper
platform must be lowered to its lowest position.
The following instructions are for the Gillig-
supplied dolly. Refer to Figure 3-17.
1. Adjust the bell housing cradle to
center with the bell housing
cradle adjustment screws.
2. Lower the upper platform to its
lowest position by opening the
pump control valves.
3. Roll the engine dolly under the
engine.
4. Center the engine dolly under
the engine. Move the rear end of
dolly to the left or right by mov-
ing the caster handle to the left or
right as needed.
5. Raise the upper platform by closing
the pump control valve and pumping
the pump handle.
6. Reposition the dolly so that the two rear adjustment screws are under the flange of the rear en -
gine support.
7. Adjust the bell housing cradle so that the bell housing cradle contacts the underside of the bell
housing.