Boat Hull
Floor support
Floor support
Tank
Deck
Clearance
height for
installation
Electrical connections for the NMEA2000 option are as follows:
RED
= Power
BLACK
= Ground
WHITE
= CAN-H
BLUE
= CAN-L
BARE
= Shield
The Gill 7014 Waste Liquid Level Sensor is a sealed unit and any damage to the black
sleeving on the probe will result in failure of the sensor.
Do not
attempt to cut the sensor to length or bend the sensor probe. Both actions will
result in sensor failure and invalidate the warranty.
If the sensor has been used in Blackwater or any other materials, special procedures
must be followed. You
must
contact Gill Sensors & Controls for instructions.
Contact details can be found at the end of this guide.
Hello.
Here is a quick guide to getting your sensor up and running.
Supplied with
M12, 5-way Micro
NMEA2000 ‘male’
connector
7014 WASTE LIQUID
LEVEL SENSOR
Sensors & Controls
7014-30-042 Iss 3
Ensure you have sufficient
clearance to get the sensor into the
tank without bending the probe or scraping the black sleeve
on sharp edges.
More information at
gillsc.com
E
T
+44 (0)1590 613900
E & OE
On the top of the sensor flange, remove the retaining screw and cover to
access the USB connection. There is an O-ring seal around the cover which
makes it resistive to removal. When replacing the cover please ensure that a
good seal is re-established.
Go to the Gill website
gillsc.com/support
to download the configuration
software. The User Manual covers sensor set-up and configuration.
To setup and configure the
sensor you will require a standard USB lead -
Type A to Micro B.
INSTALLATION GUIDANCE
CONFIGURATION
