MDE-4318D Competitive Pump and CRIND (CPC) Hardware/Software Start-up and Service Manual · May 2010
Page 5
Supported Features
Passport CPC Overview
Supported Features
The following is a list of features in this version of the CPC software:
• Simulation of Gilbarco Major Oil Company (MOC) Z180 single-line CRIND devices
• CPC CRIND text-only displays (at least 2 lines by 16 characters)
• CPC CRIND graphic displays that support text-mode emulation
• Simultaneous use of the Passport system and competitive CRIND devices and pumps
• Maximum of 24 competitive fueling positions (pump with CRIND device or pump only)
• CRIND debit - Derived Unique Key Per Transaction (DUKPT) only
IMPORTANT INFORMATION
Verify if the software version of the Passport system supports CPC before performing an installation.
Else, you may have to perform a service pack installation or software upgrade (if there is an upgrade
path).
Forecourt Configuration
Programming the Forecourt
To use CPC at a location, dispenser and CAT configuration must be programmed in the
Forecourt Installation area of the Manager Workstation. The Forecourt Installation screen
consists of seven tabs, which require specific site configuration information. Each tab must be
completed before the CPC unit is brought online.
Listed below are descriptions of each tab:
•
Dispensers
: Indicates the type of dispensers at the site.
•
Payment Terminals
: Indicates the type of payment terminals used at the site.
•
Product
: Indicates the type of fuel dispensed at the site (for example, Unleaded or Super).
•
Grade
: Indicates the grade of mixture used for each product dispensed.
•
Tanks
: Indicates the diameter and capacity of each tank.
•
Grades to Dispensers
: Indicates the grade of fuel to be dispensed from each pump.
•
Tank-Product to Dispensers
: Indicates the grade of fuel for all pumps onsite.
The following sections provide instructions to program the forecourt hardware for each tab.
Note: These programming instructions will focus on programming steps required specifically
for a Passport site using CPC. Refer to the appropriate Passport Software Installation
Manual, for additional details regarding forecourt setup for Passport system locations.
IMPORTANT INFORMATION
If you are replacing an existing POS with the Passport system, obtain a configuration report from the
existing system to assist you in completing Forecourt Installation programming.
