The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
Local IP Address
Enter the IP address to be used as the source address for all
L2TP connections based on this profile.
If this field is left empty, your device uses the IP address of the
interface used to reach the remote IP Address by the L2TP
tunnel.
Hello Intervall
Enter the interval (in seconds) between the sending of two
L2TP HELLO messages. These messages are used to keep
the tunnel open.
The available values are
to
, the default value is
C
. The
value
means that no L2TP HELLO messages are sent.
Minimum Time
between Retries
Enter the minimum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no
response.
The wait time is dynamically extended until it reaches the Max-
imum Time between Retries. The available values are
to
, the default value is
.
Maximum Time
between Retries
Enter the maximum time (in seconds) that your device waits
before resending a L2TP control packet for which it received no
response.
The available values are
E
to
, the default value is
D
.
Maximum Retries
Enter the maximum number of times your device is to try to re-
send the L2TP control packet for which is received no re-
sponse.
The available values are
E
to
, the default value is
.
Data Packets Se-
quence Numbers
Select whether your device is to use sequence numbers for
data packets sent through a tunnel on the basis of this profile.
The function is enabled with
"
.
The function is disabled by default.
Gigaset Communications GmbH
13 VPN
hybird 120 Gigaset Edition
285
