34
Te
mplat
e
G
o
, V
e
rs
ion 1
, 01.
07
.2
014
/ M
odu
leV
e
rs
ion 1
.0
ECO DECT
Gigaset Maxwell C / LHSG IM - IE-UK-International en / A31008-N4007-R101-1-X119 / applications_1_HX.fm / 4/26/18
Availability and operation of the functions
may differ on your telephone.
Deactivating the room monitor / cancelling the alarm
Deactivating the room monitor remotely
¤
Accept the alarm call press the
keys
The room monitor is deactivated and the handset is in idle status. The room monitor settings
on the handset (e.g. no ringtone) will remain activated until you press the display key
OFF
.
ECO DECT
(depending on the base)
The device range is set to maximum as default. This guarantees the best connection between
the handset and the base station. In idle status, the handset will not function (as it is not
transmitting). Only the base station will maintain contact with the handset via a low wireless
signal. During a call, the transmission power automatically adapts to the distance between the
base station and handset. The smaller the distance to the base, the lower the radiation.
To reduce the radiation further:
Reducing radiation by up to 80%
Deactivating radiation in idle status
Deactivate room monitor:
¤
In idle status press the display key
OFF
Cancel the alarm:
¤
During an alarm press and
hold
the Back key
The alarm is forwarded to an external destination number.
The receiving phone supports tone dialling.
If the alarm is activated via a VoIP connection, the DTMF signalling must take place
via SIP info or RFC2833 (
setting on the base station).
The room monitor cannot be reactivated remotely.
Reactivate:
¤
. . . use
to select
Settings
OK
ECO DECT
OK
Maximum
Range
Change
(
= off )
The range is also reduced with this setting.
It is not possible to use a repeater to increase the range.
¤
. . . use
to select
Settings
OK
ECO DECT
OK
No
Radiation
Change
(
= on)
www.internetvoipphone.co.uk | [email protected] | 0333 014 4343