123
Configuring the system settings
Gigaset N300/N300A IP / GBR / A31008-M2214-L101-2-7619 / settings.fm / 16.07.13
V
e
rsion 4, 16.0
9
.2005
Setting the base's IP address in LAN
Prerequisite:
your base is connected to a router or a PC
An IP address is required in order for the LAN to "recognise" your phone.
The IP address can be assigned to the phone automatically (by the router) or man-
ually.
u
If done
dynamically,
the router's DHCP server automatically assigns an IP
address to the phone. The base's IP address can be changed according to router
settings.
u
For manual/
static
assignment, you assign a static IP address to the phone. This
may be necessary depending on your network configuration (e.g., if your phone
is connected directly to a PC).
v
¢
Ï
Settings
¢
System
¢
Local Network
~
If the system PIN is not 0000: enter the system PIN and press
§OK§
.
¤
You can enter data in the following fields:
IP Address Type
Select
Static
or
Dynamic
.
For
IP Address Type
Dynamic:
The following fields show the current settings that the phone obtained from the
router. These settings cannot be changed.
For
IP Address Type
Static
:
You must manually define the IP address and the subnet mask for the phone as
well as the standard gateway and DNS server in the following fields.
For
IP Address Type
Static
:
IP Address
Enter the IP address that is to be assigned to the phone (overwriting the current
settings).
The default is 192.168.1.2.
For information on the IP address, see the glossary
Subnet Mask
Enter the subnet mask to be assigned to the phone (overwriting the current set-
tings).
The default setting is 255.255.255.0
For information on the subnet mask, see the glossary
Please note
To assign the IP address dynamically, the DHCP server on the router must be
activated. Please also read the user guide for your router.
