72
Handset settings
Gigaset SL75 WLAN / en / A31008-M700-B112-1-7619 / settings_hs.fm / 24.4.06
Ve
rs
ion05.
08.2
005
Depending on the mode of setting for the
date and time, you must enter the wake-
up time in 12 or 24 hour mode (see
page 67).
A wake-up call is signalled on the handset
by the selected ringer tone (page 70). The
wake-up call sounds for about 60 seconds.
The display shows
Alarm Clock
plus the
date and time.
During a call, the wake-up call is signalled
by a short tone.
The wake-up time is saved.
Deactivating the wake-up call
Requirement
: A wake-up call is sounding.
§Silence§
Press the display key or any
key.
The alarm clock is still switched on.
Protecting against unauthorised
access
Protect the handset with a PIN known only
to yourself. If a PIN is entered it is
requested when the handset is switched
on. When the phone is supplied no PIN has
been entered.
Changing the Handset PIN
You can save a 4-digit Handset PIN.
v
¢
Ð
¢
Change HS PIN
~
Enter current Handset PIN if
necessary und press
§OK§
.
~
Enter new Handset PIN (four
digits 0–9) and press
§OK§
.
a
Press
and
hold
(idle status).
Clearing handset blocking
If you enter a wrong PIN three times in a
row, the handset will be blocked. In the
display, a corresponding notification and
the handset's IP address are shown.
You can only clear the blocking via the
Web configurator.
¤
Start the Web configurator with the IP
address displayed (page 75).
¤
Change the
Handset PIN
via the
Admin
menu (page 80).
¤
Close the Web configurator (page 79).
The handset blocking is cleared.
§OK§
Press the display key to con-
firm the information on the
handset display. The handset
switches off.
a
Press the End call key to switch
the handset on again and reg-
ister with the new Handset
PIN.
Caution:
If you do not assign a PIN, every subscriber to
the WLAN has free access to your handset set-
tings.
Caution:
– Memorise the new Handset PIN well! If you
forget it, you can change it using the
Admin PIN via the Web configurator.
– For how to set/change or delete PINs using
the Web configurator, see page 80.
Notes:
– To delete the Handset PIN: leave the input
field for the new PIN empty and press
§OK§
.
– You cannot correct wrong entries when you
are entering the PIN. If necessary, cancel
the input (
a
or
”
) and start the proc-
ess again.
Notes:
– If you wish to clear the handset blocking at
a later time, press the
§OK§
display key. The
handset switches off. The message with
the handset's current IP address will be dis-
played again the next time you switch on.
– If you wish to launch the Web configurator
in a different WLAN: press the
§Scan§
display
key. This launches the connection wizard