![Gigaset CX203isdn Скачать руководство пользователя страница 11](http://html1.mh-extra.com/html/gigaset/cx203isdn/cx203isdn_user-manual_2226387011.webp)
8
Setting up the handset for use
Gigaset S44 / englisch / A31008-M368-B103-1-7619 / starting.fm / 21.2.05
Initial charging and discharging of batteries
If the handset is activated, the battery charging process is indicated on the handset by
the flashing battery icon
e
.
During handset operation, the battery icon indicates the charge level of the batteries
(page 1). The correct charge level can only be displayed if the batteries are first fully
charged
and
discharged.
◆
To do this, leave the handset in the charging cradle
uninterrupted
for
8
hours.
Your handset need not be switched on for it to charge.
◆
Once the batteries are fully charged, remove the handset from the cradle and do not
put it back again until the batteries are fully discharged.
Please remember:
◆
Always repeat the charging and discharging procedure if you remove the batteries
from the handset and re-insert them.
◆
The batteries may warm up as they are charging. This is not dangerous.
◆
After a time the charge capacity of the batteries will decrease for technical reasons.
Your handset is now ready for operation. To correctly record the time of calls and, if
applicable, messages you must now set the date and time. Depending on the network
provider, the date and time are updated automatically by the telephone network with
every outgoing call. All the settings necessary to operate the telephone can be made
easily with the Getting started wizard (page 15).
Attaching the belt clip
There are notches for attaching the belt clip on the side of the handset at approximately
the same height as the display. Press the belt clip onto the back of the handset so that
the protrusions on the belt clip engage with the notches.
The belt clip's clasp must be pointing towards the battery compartment.
i
◆
After the first battery charge
and
discharge you may replace your
handset in the charging cradle after every call.
◆
When the handset is in the cradle, it charges even if it is switched off.
◆
If the handset has switched itself off because the batteries are flat and
it is then placed in the cradle, it will switch itself on automatically.
◆
Only place the handset in the charging cradle that is intended for it.
i
To register
handsets
, refer to page 21.