Gigabyte R163-S32-AAB1, Руководство пользователя

Страница: 27 / 115

System Hardware Installation
- 27 -
3-3 Removing and installing the Heat Sink
Read the following guidelines before you begin to remove/install the heat sink:
• Always turn off the computer and unplug the power cord from the power outlet before installing
the heat sink to prevent hardware damage.
• Unplug all cables from the power outlets.
• Disconnect all telecommunication cables from their ports.
•
Place the system unit on a flat and stable surface.
• Open the system according to the instructions.
WARNING!
Failure to turn off the server before you start installing components may cause serious damage. Do
not attempt the procedures described in the following sections unless you are a qualified service
technician.
• When installing the heat sink to CPU, use T30-Lobe driver to tighten 4 captive nuts in sequence
as 1-4. The screw tightening torque: 8 ± 0.5 kgf-cm.
• To ensure the system operates properly, make sure the heatsink is seated on the processor firmly.
Follow these instructions to remove/install the heat sink:
1. Loosen the captive screws securing the heat sink in place in reverse order (4
g
3
g
2
g
1).
2. Move the rotating wires into the unlatch position.
3. Lift and remove the heat sink from the system.
4. To reinstall the heat sink reverse steps 1-3 while ensuring that you tighten the captive screws in
sequential order (1
g
2
g
3
g
4).
1
2
3
4