Gigabyte GA-F2A88X-D3HP, Руководство пользователя

Страница: 20 / 96

- 20 - Hardware Installation
1-7 Back Panel Connectors
USB 2.0/1.1 Port
The USB port supports the USB 2.0/1.1 speciication. Use this port for USB devices.
PS/2 Keyboard/Mouse Port
Use this port to connect a PS/2 mouse or keyboard.
D-Sub Port
The D-Sub port supports a 15-pin D-Sub connector and supports a maximum resolution of 1920x1200
(the actual resolutions supported depend on the monitor being used). Connect a monitor that supports
D-Sub connection to this port.
DVI-D Port (Note 1)
The DVI-D port conforms to the DVI-D speciication and supports a maximum resolution of 2560x1600.
Connect a monitor that supports DVI-D connection to this port. Please note that the actual resolutions
supported are dependent on the monitor being used and support for 2560x1600 resolution requires both
a monitor and cable that support Dual Link DVI.
USB 3.0/2.0 Port
The USB 3.0 port supports the USB 3.0 speciication and is compatible to the USB 2.0/1.1 speciication.
Use this port for USB devices.
HDMI Port
The HDMI port is HDCP compliant and supports Dolby True HD and DTS HD
Master Audio formats. It also supports up to 192KHz/24bit 8-channel LPCM audio
output. You can use this port to connect your HDMI-supported monitor. The maximum supported resolution
is 4096x2160
(Note 2)
, but the actual resolutions supported are dependent on the monitor being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(The item name may differ depending on your operating system. The screenshot below is from
Windows 8.1.)
In Windows 8.1, select Start>Control Panel>Hardware and
Sound>Sound>Playback, set
AMD High De
i
nition Audio
Device to the default playback device.
(Note 1) The DVI-D port does not support D-Sub
connection by adapter.
(Note 2) The resolution of 4096x2160 can be supported
when using an FM2+ APU; the maximum
resolution supported is 1920x1200 when using
an FM2 APU.
•
When removing the cable connected to a back panel connector, irst remove the cable from your
device and then remove it from the motherboard.
•
When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent
an electrical short inside the cable connector.