GIGA-TMS WatchMan3000N, Инструкция по установке и эксплуатации, Страница: 18 / 43

WatchMan3000N 18
© GIGA-TMS INC.
2 Operation
Patrol recording, transferring records to PC and erasing.
2.1 Record Patrol
Fix the RFID tags supplied with WatchMan3000N one each at selected locations on the route to be
covered during patrol. Instruct the personnel to scan the tags during patrol as follows:
1. Switch on handset WM3000N.
2. Press the scan button on the side.
3. Bring it near the tag (6 to 7 cm's) till a beep is heard.
The beep sound indicates successful recording of the location/tag code. The handset display will show
the code of the last tag scanned.
WatchMan3000N can store about 8192 records after which the old records have to be deleted to make
space for new. Before deletion, all records can be transferred and saved to a PC.
2.2 Transfer Records to PC
Connect base unit BC3000N to PC's USB port using the RS232-USB cable . Plug the jack of 5 V dc
adaptor supplied with the product into pin socket of BC3000N.
Next, insert the handset WM3000N firmly into the slot on top of base unit BC3000N. The message
'Cradle Detected' will appear on the display.
If the PC is already installed with WatchMan Monitor software, connect handset WM3000N and base
unit BC3000N to PC as described in
Connect Device
(If the PC is not already installed with the WatchMan Monitor software, install it by following procedure in
Chapter 1.3
Install Software and then connect device.)
Next go to Start menu and click open WatchMan Monitor.