Campetto 7 Underfloor distributor system
Seite 3 / 10
Created
01.12.2013
ROEN
Modified
01.12.2013
ROEN
Object-ID
359749
1 General information
1.1 Marking concept for hazards and hints
Hazard
Hazardous situation which will cause serious injury or even death if it is not prevented.
Caution
Hazardous situation which could cause slight to moderate injury if it is not prevented.
Hint
Indicates information which does not concern personal injury, e.g. hints in respect of material damage.
Protective measures
Increase safety by applying a protective measure.
1.2 Responsibilities of the operator
-
Make sure that this document is always kept in a safe place in a legible form together with the product.
-
Read these instructions carefully before first start-up of the product.
-
This product has been developed and produced exclusively for the use indicated in these documents.
Every other use, which is not mentioned explicitly, could affect the intactness of the product and/or
could constitute a source of danger.
-
The manufacturer rejects any liability for damage which has been caused by incorrect or non-intended
use of the product.
-
In countries, which do not belong to the European Community, the national legal reference regulations
as well as the standards and regulations applicable in these countries have to be observed for warranty
of a corresponding safety level.
-
The installation has to be carried out according to the applicable regulations.
-
The manufacturer assumes no liability for inexpert execution of installation as well as deformations
which may occur during operation.
-
The electric power supply has to be switched off before executing any action on the installation.
-
Exclusively original parts of the manufacturer shall be used for maintenance. Maintenance work may
be carried out by qualified staff only.
-
All procedures which are not explicitly mentioned by the manufacturer in the instructions are not per-
mitted.
-
The packing material must not be stored within the reach of children as it could be a potential source
of danger.
-
The product must not be installed in hazardous environments. Flammable gases or fumes represent
a serious security risk
-
Energy supply of the underfloor distributor has to be protected in accordance with applicable regula-
tions and manufacturer’s details.
-
It must be checked whether the earthing system has been installed properly. The metal parts of the
underfloor distributor must be connected to this system.
-
If a heating is installed by customer, it is important that the system will be protected by RCD 30mA.
-
The manufacturer disclaims any liability with regards to safety and efficient operation of the underfloor
distributor if components are used in the underfloor distribution system which were not approved by
the manufacturer.
-
On no part of the underfloor distributor changes should be made, under no circumstances.
