Floor socket outlets FONTO
Page 4 / 18
Created
12.12.2016
KHSH
Modified
08.07.2020
roen
Object-ID
1144626
2 Introduction
To ensure proper installation, the following steps and notes must be complied with under all circumstances.
Only this way can it be ensured that the product will work to complete satisfaction.
Hint
Read all instructions before starting installation. Our sales department will be happy to answer any questions
you may have.
2.1 Disposal of the device
This product must not be thrown in the garbage.
In accordance with official local and national regulations, this product is to be recycled appropri-
ately.
European directive 2012/19/EU; waste electrical and electronic equipment (WEEE).
2.2 Technical data
This electrical distribution box (see type label) is manufactured to standards EN61439, IM22 and complies to
EU low voltage directive 2014/35/EC.
Nominal voltage, nominal power and max. permissible fuse are mentioned at the type label
Short circuit resistance
max. 10 kA or manufacturing documents
Rated peak withstand voltage
4 kV
Rated insulation voltage
400V - Test voltage: 2.5 kV
Temperature range
-25°C to +40°C
Max. relative humidity
100% at +25°C decreasing linearly to 50% at +40°C
Max. Altitude
2000m above sea level (by using above 2000m consult the
producer)
Pollution degree
3
Transport and Storage
Please only use grab handle or lifting eyes. No special storage.
Be aware that the packaging is not damaged.
Cleaning
If dirty, clean with cleaning tissue or brush. Do not use abra-
sives or solvents
The use of the distribution box may only by having a properly constructed and function checked (measured)
low-voltage system. If there are special operating conditions, please contact your dealer or the manufacturer.
The feeder must be according to the rule (ÖVE, VDE or national norms) resulting cross-section. In order to
avoid electrochemical corrosion of the power terminals and busbar, only copper wire or aluminum wire with
AlCu-terminals can be connected.
If the distribution has mechanical damage (broken cable or sockets, cracks, fissures, ....) and/or electrical
defects the distribution box may not longer be used.
Periodic inspections are according to the current national guidelines.
Repairs and inspections should only be done by the professionals
(in accordance to national regulations) by using original spareparts
to ensure the users safety and to ensure proper function.
