3
Consult the factory for special requirements that must be met if the
pump is to operate beyond one or more of the limits specified above.
U . S .
(Metric)
Volume ............................................................................. 5.5 GPM .................................. (20.8 l/m)
Discharge Pressure ................................................5075 PSI ................................. (350 bar)
Inlet Pressure ..............................................................90 PSI ....................................... (6.2 bar)
Stroke................................................................................0.79” ........................................... 20mm
R P M ........................................................................................................................................... Up to 1450 RPM
Plunger Diameter.......................................................0.71” ........................................... 18mm
Temperature of Pumped Fluids .............................160
o
F ........................................ (70
o
C)
Inlet Ports ................................................................................................................................. (2) 3/4" BSP
Discharge Ports .................................................................................................................. (2) 1/2" BSP
Shaft Rotation ...................................................................................................................... Top of pulley towards fluid end
Crankshaft Diameter ....................................................................................................... 28mm
Key Width ............................................................................................................................... 8mm
Shaft Mounting .................................................................................................................... Either side
1
Weight ...............................................................................36.5 lbs. ................................... (16.6 kg)
Crankcase Capacity ...............................................30fl.oz. ...................................... (0.89 liters)
Specifications
Model P450-5100
RP M
G P M
2000 P S I
3000 P S I
4000 P S I
5000 P S I
800
3.0
4.1
6.2
8.3
10.3
933
3.5
4.8
7.2
9.7
12.1
1066
4.0
5.5
8.3
11.0
13.8
1200
4.5
6.2
9.3
12.4
15.5
1450
5.5
7.6
11.4
15.2
19.0
P 4 5 0 -5 1 0 0
H OR S E P OW E R R E QU IR E M E N T S
N O T E S :
In order to drive the pump from the side opposite the present shaft extension, simply
remove the valve casing from the crankcase and rotate the pumps 180 degrees to the
desired position. Be certain to rotate the seal case (item #20) as well, so that the weep
holes are down at the six o'clock position. Exchange the oil fill and the oil drain plugs,
also. Refer to the repair instructions as necessary for the proper assembly sequence.
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.
We recommend a 1.15 service
factor be specified when selecting
an electric motor as the power
source. To compute specific pump
horsepower requirements, use the
following formula:
HP = (GPM X PSI) / 1450
SPECIAL NOTE:
The theoretical gallons per revolution
(gal/rev) is 0.00379.
To find specific outputs at various RPM,
use the formula: GPM = 0.00379 x RPM
Содержание P450-5100
Страница 4: ...4 P450 5100 Exploded View...
Страница 11: ...11 P450 5100 PUMP DIMENSIONS INCHES MM...
