Giant MP4120-SWS, Инструкция по эксплуатации / Руководство по ремонту и обслуживанию

Страница: 9 / 12

REPAIR INSTRUCTIONS - MP4120-SWS/MP4124-SWS
9
39 40 41 41A
15. Replace the rear v-sleeve assembly (#35A-35D) and replace the
snap ring (#36).
16. Reinstall the pressure ring (#39), v-sleeve
(#40), support ring (#41), and intermediate
ring (#41A) into each plunger bore. Re-install
the spacer ring (#52A).
17. Reassemble the inlet valve assembly in the reverse order of step #6. Make certain all the compo-
nents are press fit together and that the spring retainer (#54) is slightly counter sunk in the valve
housing (#52). Grease the o-ring (#53) and replace it on to the valve housing. Reinstall the entire
inlet valve assembly into the manifold (#43). Replace the tension plugs (#42A) and tighten.
18. Reassemble the discharge valve assembly by placing the valve plate
(#45), spring (#46), and spring retainer (#47) on top of the valve seat
(#44). Press fit together. Place the entire discharge assembly into dis -
charge port making certain the assembly is properly seated. Replace
discharge plug (#48) and tighten securely.
19. Again lubricate the plungers (29B) and slide the manifold (#43) gen -
tly and evenly over the plungers. Press the manifold firmly into place
against the crankcase (#1). Replace the spring washer (#50A) and
tighten the manifold stud nuts (#50) to 59 ft.-lbs. (80 Nm).