4
unit operation (cont.)
GENERAL RULES TO OBSERVE BEFORE
AND DURING OPERATION:
•
Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners, low or flat
tires, etc., and repair or replace prior to operation.
DO NOT OPERATE A MACHINE THAT IS WORN OR
DAMAGED – SERIOUS INJURY OR DEATH CAN RESULT.
•
Clear the entire work area of all debris that could cause damage to or become entangled in the unit. Rocks and large
branches can wedge themselves between the impeller and housing, causing equipment damage or personal injury. If
in doubt, remove it.
•
Do not start unit until you are ready to begin blowing, and promptly shut off unit as soon as operation is complete.
•
Keep hands, feet and clothing away from rotating parts. Never place your feet or hands in path of discharge.
•
Use proper discretion in selecting your debris removal pattern, especially on uneven terrain. Avoid steep hills,
especially if surface is wet.
Do not travel straight down slopes exceeding 14 degrees. If tires begin to slip when
climbing a slope, the grade is too steep for safe operation. Angle the unit to a less steep slope until tires stop slipping
and traction is regained.
•
Be keenly aware of your surroundings while operating unit – children and pets can pop out of nowhere.
•
Learn to listen to your machine – being aware of what a well-running unit sounds like can alert you to a potential
problem. A straining engine or clanging impeller means that trouble is almost sure to follow.
TO CHANGE AIR DISCHARGE DIRECTION:
•
To direct air discharge out from the front of the
machine, open the forward air deflector door,
mounted on the front of the discharge end of
the blower, by pushing the control lever to the
front of the machine. This feature is ideal for
such things as blowing debris from a wall or
fence. Adjust engine speed to increase or
decrease air discharge rate.
FRONT
SIDE
•
To direct air discharge out from the side of the
machine, close the forward air deflector door by
pulling the control lever toward the back of the
machine. Adjust the discharge deflector up or
down to control angle of discharge. This feature
is ideal for such things as blowing debris into
neat rows. Adjust engine speed to increase or
decrease air discharge rate. IMPORTANT:
SHUT UNIT DOWN BEFORE ADJUSTING
SIDE DEFLECTOR.
ADJUST