GIA GIA-AT-O-200VA1, Инструкция для владельца и по установке

Страница: 14 / 24

– 14 –
PART 4: Instructions of Usage and Daily Operations of Heat Pump
■ Instruction of Buttons
Note: It shows the temperature of tank water in unattended operation, while it shows no value
in stand-by status. When the tank water temperature indicator flashes, it means the machine’s
disinfection function is on.
■ Operation Instruction
(1) Turn on / off the Machine
With the power connection, press the button “On/Off”, then the heat pump will turn on. Press
the button “On/Off” again, the heat pump will turn off.
(2) Mode Selection
When the machine is on, you can select the mode “automatic”, “heat pump” or “assistance”
(electrical assistance).
Note: heat pump mode and assistant mode cannot be used at the same time.
● When under “automatic” or “heat pump” mode, the compressor has 3-minute starting delay
protection function.
● In order to avoid starting frequently, when it reaches the setting temperature and stops,
the heat pump will restart when the temperature of tank water 4ºC lower than the setting
temperature.
● When under “automatic” mode, turn on the heap pump and let it heating until the tank
water temperature reaches 52ºC and stop, then select the “assistant” mode to increase the
water temperature to 70ºC.
● When the display is on, press the mode button for at least 3 seconds, and then press ▲ or ▼
button referring to the follows:
F1: the temperature of discharge;
F2: the temperature of environment;
F3: the temperature of pipes;