E40.0.5X.6C-01
Operating Manual EASY
LOG
80IMP…
page 8 of 16
6. Operation
6.1 Operating possibilities at the device - min/max value memory
Function
Procedure
Display max-value
Push button
shortly
The max-value is displayed for 4 seconds.
(The max-value display function is signalled by the display el-
ement “MAX”).
Note:
You can immediately deactivate the max-value dis-
play by pushing the button again.
Delete max-value
Push button
for about 5 seconds.
“CLr” is displayed and the max-values of all measuring
channels are deleted.
Display min-value
Push button
shortly
The min-value is displayed for 4 seconds.
(The min-value display function is signalled by the display el-
ement “MIN“).
Note:
You can immediately deactivate the max-value dis-
play by pushing the button again.
Delete min-value
Push button
for about 5 seconds.
“CLr” is displayed and the min-values of all measuring
channels are deleted.
6.2 Operating possibilities at the device - signal edge selection
Function
Procedure
Select input signal
edge
Push button
and
at the same time
The main display shows „EdGE“.
The main display shows the active input signal edge.
Adjust via button
and
the desired selection.
Selection Input signal type
Impulse detection
RISE
IMP/T: TTL signal
Rise edge
IMP/S: switching contact Contact opens
FALL
IMP/T: TTL signal
Fall edge
IMP/S: switching contact Contact closes
Important: To change the input signal, the logger-display
must show ‚Stop‘, so no data saved, and the logger must not
be connected to the EASYBus.
Press Button
again to confirm your adjustments and to
leave the menu..
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving
2
2
3
3
SET
1
3
2
3
SET
1
