E44.X.01.6C-04
Mounting- and Operating Manual GIR 300
page 3 of 34
1
Safety
1.1 General note
Read this document carefully and get used to the operation of the device before you use it.
Keep this document within easy reach near the device for consulting in case of doubt.
Mounting, start-up, operating, maintenance and removing from operation must be done by qualified, spe-
cially trained staff that have carefully read and understood this manual before starting any work.
The manufacturer will assume no liability or warranty in case of usage for other purpose than the intended
one, ignoring advices of this manual, operating by unqualified staff as well as unauthorized modifications
to the device.
1.2 Intended use
The device is a universal microcontroller based display -, monitoring - and controlling device.
The device has 1 universal-input, 2 relay outputs and an EASY Bus-interface. It can be used by measure-
ment and
–regulation, limit monitoring, etc.
Prior to fulfil the referring requirements, the device has to be configured on the base of this manual. Wrong
configuration may lead to malfunction in the application. The commissioning expert / the operator is liable
for a suitable configuration.
The device is only to be operated in control panels ore suitable electric housings, where the connection
terminal area is sufficiently protected against touch.
The device is designed for industrial or commercial use.
Outdoor installation without suitable means of protection is not allowed.
The counting function is not to be used for e.g. consumption metering in the sense of the measuring in-
struments directive 2014/32/EU.
The safety guidelines of the manual are followed!
The unit does not contain any components that you can service or repair yourself.
All the described operations are only to be performed of skilled personnel that are authorized by the opera-
tor.
Any other use or use exceeding this is considered as non-conforming and leads to the expiration of any
liability or guarantee claims from the manufacturer.
Note: Combination / connection to other electrical equipment with CE marking does not automatically de-
liver a conform system. A new evaluation of the system’s conformity to the low voltage directive
(2014/35/EU) and EMC directive (2014/30/EU) by the manufacturer may be necessary, eventually others
have to be considered (e.g. machinery directive).
1.3 Skilled personnel
The mounting, electrical installation, start of operation, maintenance and decommissioning must only per-
formed by a skilled electrician.
Users of the readily installed device have to be sufficiently skilled in the operation of the device and able to
avoid risks. The operator of the arrangement is responsible for sufficient qualification the operators.
