GHARiENi Gharieni MLX Quartz, Инструкция по эксплуатации

Страница: 14 / 48

13
6.2 Space requirements
Before setting up, make sure that there is enough space for the bed.
The minimum space required is: length = min. 300 cm * width = min. 180 cm.
6.3 Start-up
1. Allow the MLX to acclimatise for at least 2 hours after delivery before
using the bed.
This allows the temperature sensor to adopt room temperature.
Otherwise, the temperature sensor will output a value that the system cannot
process.
2. If the MLX should switch off once when it is switched on due to unplugging or
a power failure, the glass operating panel remains black when it is subsequently
put into operation.
Disconnect the MLX from the mains and leave the bed de-energised for
5 minutes. Then plug the mains plug back in.
The MLX will now start up normally and return to normal operation.
3. After installation, all control elements must be easily accessible.
The floor must be even, clean, and slip-resistant.
4. After installation, equip the MLX with the supplied dry special quartz
sand only (approx. 180kg; also available from Gharieni). Distribute the
sand evenly.
5. Never fill more than 180 kg of the special quartz sand!
6. Place the sand cushions (if available) on the sand, they will be heated
automatically.
7. Cover the sand using the supplied thermal cover. Repeat after each treatment to
protect the sand from cooling down.
8. Connect the MLX to a properly installed shockproof socket (100 - 250 V,
50/60 Hz, 450 Watt max.) only.
9. Adjust the temperature control to the desired temperature.
The warm-up time is approx. 10 hours. Now you can adjust the temperature
(preferably overnight). All electric components are designed for continuous
operation. Leave the MLX connected to the mains when used daily.
10. Disconnect the MLX from the mains if you do not use it for a longer period
(e.g. vacation).
11. Adjust the height to the lowest level when placing a customer on the MLX.
Then adjust the height to the desired level during treatment (chapter 9.4 and
chapter 9.3.1).
12. The sand should perfectly take on the shape of the body for optimal results.
For this purpose, push some sand to the body of your customer.
13. After treatment, adjust the height to the lowest level, so your customer can leave
the MLX easily.