gfm GF-Primo Dolly, Инструкция по эксплуатации и правила безопасности

Страница: 72 / 92

71
Cover for emergancy buttons
Button for
upward
motion
Button for
downward
motion
12 Emergency Operation of the Column
The GF-
Primo and GF-Secondo
Dolly’s electronic is equipped with a back-up systems to enable
movement of the column in an emergency situation.
Emergency situations are:
o
Defective or non-functioning electronic (HCU cannot operate the electronic)
o
Defective or lost HCU
Attention:
Emergency operation is not for working with! Using the column with a under load with
mounted camera or camera operators is not allowed!
Attention:
As soon as the emergency switch is activated the column moves with a preset speed
and NO Ramp. Ensure that no equipment or persons are on the column. Jib arms etc
must be dismantled prior to activation of the emergency switch. Working in emergency
mode is not allowed!
To activate the emergency mode proceed as follows:
Using a 2.5mm Allen Key, remove the cover of the emergency switch by unscrewing the 4
bolts.
Upon removing the cover, 2 white buttons can be seen.
To move the column up, press the top button
To move the column down, press the bottom button
Attention: When replacing the cover, ensure the circuit pins are inserted into the circuit
board connector correctly and gently to avoid damage.