gfm GF-Primo Dolly, Инструкция по эксплуатации и правила безопасности

Страница: 50 / 92

49
11.2
General HCU functions
The following describes general functions such as selecting various speed and ramp settings.
11.2.1 Setting Ramps RMP and Speed SPD
A Ramp is the strength of acceleration and deceleration of column when starting or ending a
movement. The higher the val
ue or number, the softer the start or stop is. A low value such as “0”
gives an abrupt start and hard stop. The ramp range is 0 to 22.
The Speed adjustment range is from 0 to 22 whereby 0 is slow and 22 the fastest speed.
For example to change from Ramp 5 to Ramp 10 Ramp proceed as follows
Press and hold the RMP button.
Press the Rocker Switch up, until 10 is reached
Release the Rocker Switch first, then release the
RMP button.
To change the column speed proceed in the same
manner but press the SPD button instead.
Info: The Speed and Ramp can only be changed in
NORMAL, MARKER und RECORD modes. In
ENTER und PLAY modes, changes are not
possible.
Setting the Ramp Setting the speed
Selection 1: RMP 5, SPD 22
Selection 2: RMP 10, SPD 10