gfm GF-Primo Dolly, Инструкция по эксплуатации и правила безопасности

Страница: 43 / 92

42
11 Operating the Hand Control Unit (HCU)
The following explains how to use the HCU.
Info:
The HCU can only be used when switched on and when paired with the respective
dolly / electronic!
11.1
HCU Settings
The HCU display shows you various settings and provides information such as the following:
o
User settings for individual operators or changing from settings
o
Display settings such as brightness, contrast, selecting column movement in mm or imperial
o
Information about the Dolly
To select the menu proceed as follows:
Ensure that the HCU and column are connected (refer to chapter 7, Activating the HCU and
the Dolly).
Simultaneously press the RMP and SPD buttons. This will open the menu.
Attention:
The menu can only be accessed in NORMAL mode.
The different modes are described in chapter
„11.3. Special HCU modes
Scroll through the various menu points by using the Rocker Switch to go up or down.
Pressing the ENTER buttom will open the respective menu point.
Button combination for Menu