3
GAIN
controls the boost / cut gain of the filter. Center position (12 o’clock) is
flat setting,
neither boost nor cut is applied. Range: -15 dB to +15 dB.
Q
controls the bandwidth (sharpness) of the filter’s resonance. Turn up the knob clockwise
to get sharper resonance (smaller bandwidth).
FREQ
controls the center frequency of the filter’s resonance. Range: ~40 Hz to ~8 KHz.
MASTER
provides up to -12 dB volume attenuation and up to +12dB of volume boost.
Controls
EQ-1
EQ-2
X
X
no connection
INP-1
INP-2
OUT-2
OUT-1
EQUALISYS
Mode Configuration
The three EQ configuration modes are selected using the MODE switch. Each mode and
its uses is explained below.
In
series
configuration the two EQs are serially connected as shown. IN-2 and OUT-2 are
not used in this configuration. This mode is useful to get two parametric EQ curves com-
bined, for example you can apply a sharp cut/boost at 200 Hz while applying a broad cut/
boost around 3 KHz.
EQUALISYS
Multimode Parametric EQ
User Manual
EQ-1
EQ-2
X
INP-1
INP-2
OUT-2
OUT-1
EQUALISYS
PARALLEL mode
SERIES mode (2-band parametric EQ)
