GEZE TSA 160 NT F, Схема подключения

Страница: 19 / 64

TSA 160 NT
19
Contact sensor inside
6.1 Key switch
à
Setting the contact type parameter:
à DPS: Set
cB
to
01
(factory setting).
à ST220: Set the “Signals”, “Input signals”, “KB”, “KB
contact type” to “normally opened contact”
(factory setting).
à
S1, S2: Set parameter 12 to 01 ”normally opened contact“.
à
Key switch SCT, single-pole, flush-mounted,
AS500 without euro profile half cylinder, mat. no. 117996
à
Accessories:
à
Euro profile half cylinder, mat. no. 090176
à
Additional contact, mat. no. 024467
20 KB
2 24V
KB
7 Contact sensor inside
à
The KI input is active in the operating modes AU and LS.
à
In the case of 2-leaf systems the contact sensor inside can be connected to the active leaf control or to the passive
leaf control.
à On activation the active leaf opens and, if switched on, the passive leaf.
à The sensor for monitoring closing can also be used as a contact sensor inside.
à Setting the parameters:
à
DPS: Set
f1
to
0 2
.
à
ST220: Set the ”Signals“, “Input signals”, “SI1 – terminal SIS”, “SI1 function” to “SIS and KI”.
à
S1, S2: Set parameter 8 to 02 “SIS and KI”.
à
For input KI an activation delay (
a I
, “KI delay”) can be set if a closing position switch is installed (see chapter
“Closing position monitoring, closing position blanking SIS, Push And Go“). This time is added to the general
activation delay time (
D l
, “Opening delay”).
Setting the parameters:
à DPS: Set
a I
to the desired delay time (0 s ... 10 s).
à ST220: Use the buttons

or

to set “Signals” “Input signals”, “KI”, “KI delay” to the desired delay time
(0 s … 10 s) and press  .
à
S1, S2: Set parameter 14 to the desired activation delay (00 s … 10 s).
7.1 Radar movement detector GC 302 R
à
Upon activation, the output of the GC 302 R is closed
(24V applied to the KI input).
à
Setting the contact type parameter:
à
DPS: Set
cl
to
01
(factory setting).
à
ST220: Set the “Signals”, “Input signals”, “KI” and “KI
contact type” to “normally opened contact”
(factory setting).
à S1, S2: Set parameter 13 to 01 “normally opened
contact” (factory setting).
à
GC 302 R black, mat. no. 124087
à
GC 302 R according to RAL, mat. no. 124088 (remote control
does not work with detector cover mounted, LED not visible).
à
The GC 302 R is a directionally sensitive radar movement
detector.
à
Follow the installation instructions.
WH
BU
BK
BN
50 mA +UB
-UB
GC 302 R
1
2
3
4
5
24V
KI
GND
2
21
1
KI