ECdrive H
6
About this document
3
About this document
These instructions describe the pre-installation of the ECdrive H automatic sliding door drive.
4
Overview
4.1 Diagrams
Drawing no.
Type
Name
70517-0-001
Drive drawing
Drive ECdrive H
70517-2-0201
Component drawing
Track, bespoke, for ECdrive H
70517-2-0224
Component drawing
Cover PL 200×40, bespoke, for ECdrive H
70517-2-0223
Component drawing
Side plate, right/left for ECdrive H
70517-2-0229
Component drawing
Leaf spring for cover ECdrive H
The diagrams are subject to change without notice. Use only the most recent version.
4.2 Tools and aids
Tool
Closer size
Tape measure
Marking pen
Torque spanner
Allen key
2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 6 mm
double open-ended spanner
8 mm, 10 mm, 13 mm, 15 mm
Screwdriver set
Floor guide slit up to 6 mm; cross-slot PH2 and PH4
Torx bit
Tx 20
Side-cutting pliers
Crimping pliers for cables
Wire stripper
Multimeter
Ring spanner
8 mm, 10 mm
Pin punch
4 mm
Display programme switch/Service terminal ST220/GEZEconnects
4.3 Torques
The torques are given at the respective installation step.
