G-Code/E2 Series
1
Quick Start Guide G-Code/EEN-2040
This manual has been designed to guide you through basic settings of your IP
devices, such as installation and configuration for using them.
1. Connect cables to IP device
Connect each cable to the device. To see the correct positions of all connectors,
refer to the following image below.
Make sure to set the input configuration switch to a relevant video
standard position (PAL/NTSC) before you turn on the encoder.
The device must be rebooted to apply the changed video standard after
you change the position of the switch.
Video In
OFF
PAL NTSC
Input Configuration
Switch (PAL/NTSC)
* Models herein and their appearance
are subject to change without any prior
notice.
Power DC 12V
Network
Port
