6. Sending jobs to the plotter from GSPPlot
You can send a cut-only job from GSPPlot to the Gerber Tempo 600, or if you have created a
print/cut job, print Graphtec Type 2 (right angle) targets using the GERBER EDGE® and the
Gerber Tempo can automatically acquire them.
To print Graphtec Type 2 targets
1
In GSPPlot, open the print/cut job.
2
Click Setup > Print Options to open the Print Options dialog box.
3
Click Targets to open the Target Configuration dialog box.
4
Turn on Graphtec Type 2 targets to print right angle targets in the four corners.
5
Optionally, turn on Graphtec Intermediate Targets to add extra targets along the edge
of the graphic.
6
Click OK.
7
Print the job with the Graphtec Type 2 targets on the GERBER EDGE.
To send jobs to the Gerber Tempo 600 from GSPPlot
1
Open a cut-only or print/cut job in GSPPlot.
2
Click Setup > Device Select and choose the Gerber Tempo 600 and click OK.
3
Click Cut/Pounce to send the job to the plotter.
8 of 15