Instructions for Use
Bodystik
Serial no.: xx|8|301|yyy and 2301xxxxx
Version: 7 | Release date: 02. August 2021
Page 85
Personal injury possible.
Reason: misinterpretation of obvious measuring errors
(drift) caused by liquid in the tubes. Therefore:
•
Clean tubes only externally!
•
Replace dirty tubes!
Attention
Bodystik could fail.
Reason: Damaged connections. Therefore:
•
To disconnect electrical connections, always pull the
plug and never the cable!
9.1
Single Use
For instructions on handling bacteria and virus filters and
noseclips, read:
•
Chap. 7.6 “Exchange of Disposable Products /
Disinfection”
9.2
Disinfection
In spite of the high filtration rate and single use of the bacteria
and virus filters, it is necessary to clean and disinfect at least
once a week all components which come into contact with the
patient respiratory flow. This applies to the flow unit, Ergoflow,
shutter cage and shutter head or shutter block.
All parts of the Bodystik can be cleaned from dirt with a soft
cloth using a cleaning solution / weak soap suds.
All parts of Bodystik which come into contact, or could come
into contact, with the patient must be treated with a surface
disinfection. Otherwise, these can be wiped with a soft cloth
using a weak soap solution.
