Born For FPV
22/24
The Essential inspection before
flight.
Most of the time, the cause of FPV crash is not checked before takeoff. For the safety, we suggest
that you should take a check before each flight. The steps are as follows:
1. Turn on the remote control and select the correct model; please confirm that the unlock switch
is in the locked state and the throttle position is in the lowest position;
2. Please check if the appearance of FPV is damaged. If there is damage, please repair first, do
not fly with damage;
3. Please confirm whether the propellers are installed correctly and check whether the
propeller's steering is correct. Please confirm whether the motor screw is tightened. If it is not
tightened, there is a risk of propeller shooting;
4. Check the battery voltage. In the fully charged state, 3S battery voltage should be 12.6V, 4S
battery voltage should be 16.8v, 6S battery voltage should be 25.2v;
5. Check whether the battery is firmly fixed on the FPV by the strap and whether the battery's
wire is fixed to avoid being cut by the propellers;
6. Observe the flight area to see if there are safety risks, such as someone entering the flight area,
and observe the weather conditions to judge whether there are flight conditions;
7. Open your Goggle or FPV screen and check if there is a frequency conflict with you. If there is a
conflict, do not power your FPV, so as not to interfere with others!
8. After connecting the battery, put the FPV on the ground and do not move it until three beeps
are heard and the gyroscope is calibrated successfully;
9. Before taking off, unlock and rotate the propeller to observe whether the propeller will scratch
the antenna or power line
10. It's finally the last step: Unlock and Arm your drone.
PS: if you choose to fly near the water source, please pay attention to safety. It is difficult to
salvage the FPV when it falls into the water, and the FPV's Water falling is excluded on the
Warranty Policy.
