17
Note:
The beeper and LED cables can be wired onto the same output. In this case, the
reader will beep along with a flashing LED according to access conditions.
1.7.2 Define Output Conditions
After wiring the beeper or LED, specify the conditions to trigger the beeper or LED on the
GV-AS Controller’s Web interface. Here we use GV-AS210 Web interface as an example.
1. On the controller Web interface, click
Output Setting
. This page appears.
2. Find the output wired to the beeper or LED and set up the alarm condition (Access
Granted or Access Denied) to set off the beeper or LED.
a.
Output Type:
Select
Normal
,
Toggle
or
Pulse
. If you select Pulse, you can specify
the number of seconds to trigger the beeper or LED.
b.
Output Condition:
Select the door and the alarm condition to trigger the beeper or
LED.
3. Click
Submit
.