Geometrics G-822A, Руководство по эксплуатации

Страница: 39 / 62

Geometrics, Inc. G-822/G-823 Magnetometer Manual
33
The following describes CM-201 and the files that will be installed on your C:
drive:
install.bat
This is a batch file used to copy the contents of the floppy onto your hard disk. A
directory called "GeoUtil" is created on the "C" drive, then all of the files are copied into
that directory. After the files are copied, this batch file then runs Cm201set.bat
cm201set.bat
This batch asks the user questions and based on the answers to these questions creates a
batch file called "cm201.bat". The questions include such things as, to which COM port
the CM-201 counter is connected.
cm201.bat
This batch file is created by Cm201set.bat. It invokes cm201go.exe to send any
command lines necessary to correctly configure the CM-201 counter(s) for the users
application.
cm201go.exe
This program is intended to send any commands to correctly configure the CM-201
counter module(s). Normally the commands are taken from the file cm201go.cnf, but this
can be overridden if needed.
The calling syntax for this program is:
Cm201go FileName.cnf /b:BBBBB /p:P /i:I /d:D
Where:
BBBBB Is the baud rate that the CM-201 starts at. Normally this is 9600.
P The port number /p:1 would mean use COM1. This parameter is
optional. If it not specified COM1 will be used.
I The interrupt number to use. This parameter is optional. If it is
not specified the normal interrupt for the COM port is used.