Geometrics G-822A, Руководство по эксплуатации

Страница: 38 / 62

Geometrics, Inc. G-822/G-823 Magnetometer Manual
32
9.0 ACCESSORY SOFTWARE
9.1 CM-201
CM-201 is a program that facilitates sending a command start-up file to the G-823A
counter(s) and initiating system operation. The program is executed by typing “cm201”
at the DOS prompt and pressing return. CM-201 expects a counter command file that
must be called cm-201go.cnf. This file is a list of counter commands, each followed by a
carriage return that may be required to configure the counter to your application.
This software and all its necessary files may be installed on your system by placing the
Install disk in either your a: or b: floppy drive, switching to that drive, typing “install” at
the DOS prompt and pressing return. Install will ask a number of questions to which you
should respond to configure the CM-201 counter to your system and create the cm-
201go.cnf file.
If, after installing CM-201, further commands are required (such as CLOCK) to configure
CM-201 operation to your application, they may be added to the cm201go.cnf file by
editing this file with any suitable text editor.
Figure 14. G-823B Installed as base-station magnetometer.
G-823B
magnetometer
installed using
sensor staff
sections and tripod
base. This
installation
provides a ridged,
non-ferrous
support for the
sensor that
presents minimal
wind resistance.
Photo on left
shows installation
combined with a
GPS receiver.