Geo Knight Digital Combo DC16, Руководство пользователя

Страница: 12 / 30

12
There is a curved 1/2-moon cap
holddown device for stretching the
cap over the curved bottom table.
Simply pull the back strap of the
cap behind the pedestal and under
the 1/2-moon shaped bracket. This
will hold the cap in place for proper
printing.
Cap Hold-down Device
(For Cap Attachment Only)
The table can be easily adjusted in a straight position if the heat platen
does not correctly line up with the pressing surface. The pedestal the
table rests on can slide front to back on the base of the machine. Loosen
the screw in the gibb plates that holds the pedestal in place in order to
adjust its position.
The pedestal can also be slightly rotated in order to align with the upper
platen. Loosen all (4) screws holding the gibb plates in place, position/
rotate the pedestal to the desired place, and retighten the gibb plates.
Aligning the Pedestal
The standard tables included with the DK7
or DK8 will accommodate most items.
However there are other sized bottom
tables that are instantly interchangeable.
For the DK7, there are 3 different curved
forms (the top heat platen stays the same).
The mid-sized and youth-sized forms
are not included with the press. The mid-
sized “EURO” form is especially useful
for solving wrinkling of caps in the middle
area for lower-profile tight-fit caps.
Custom pedestals, bottom tables, and other
custom solutions are also available from the factory.
Optional Forms / Custom Pedestals