GENMAX GM2800iA, Руководство пользователя, Страница: 15 / 27

15
Recoil Starter
1. Remove all the loads out of the output;
2. Turn the fuel switch to "ON";
3.
Turn the engine switch to "ON";
Firmly grasp and pull the recoil handle slowly until
4.
you feel increased resistance. At this point, apply a
rapid pull while pulling out from the inverter. Pull the
Recoil Handle out from Inverter (see Figure 6).
Tip: When pulling the hand starter, hold the
generator carrying handle firmly, to prevent the
generator from overturning.
1. Remove all the loads out of the output.
2. Turn the fuel switch to "ON".
3. Press "START UP" to START the generator
.
Electric Starting
1. Remove all the loads out of the output.
2. Turn the fuel switch to "ON".
3. Press "ON" on the remote control for 1 second and
the generator runs normally.
Figure 6
Remote Start
Remote Control Pairing
1. Press the “START” button for 5 seconds, release it
when the “START/MATCH” indicator lights up.
2. Press “ON”/“OFF” on the remote control until the
indicator lights off.
3. Press “ON” on the remote control for 1 second,
when the generator starts, the function is paired
successfully.
Tip: The remote control supplied with the generator
has been paired successfully.
10
10
10
10
Dual Fuel
1. Using fuel oil: Turn the oil/gas switch to GAS., and
then start and run the generator according to normal
start-up steps
;
2. Use gas: turn the oil and gas conversion switch to
gas, open the gas cylinder, press the thickening valve
button on the secondary pressure reducing valve, and
start the generator according to the normal start-up
steps.
Procedure For Connecting Gas Pipes
1. Connect the pressure reducing valve assembly to
the gas tank and tighten it
;
2. Connect the dedicated gas hose to the generator;
3. Switch the oil/gas switch to gas gear;
4. Open the gas valve on the fuel tank and start the
generator according to the normal start-up steps.