Genie Z-22 Bi-Energy, Руководство по обслуживанию и ремонту

Страница: 52 / 123

Service and Repair Manual September 2015
Engines
40 Z-34/22 Bi-Energy Part No. 1268515
7 Carefully tighten each bolt evenly until the
engine drive pulley slides off the shaft.
Component damage hazard.
The engine drive pulley and/or
shaft can be damaged if the
bolts are not tightened evenly.
8 Loosen the set screw on the pulley bushing,
then slide the pulley bushing off of the engine
shaft.
1 gap
2 shaft
3 set screw
4 engine drive pulley
5 engine drive pulley bolt
6 shaft bushing
7 woodruff key
How to Install the Engi ne Drive Pull ey
How to Install the Engine Drive
Pulley
Note: The generator pulley must already be
installed before performing this procedure. Refer to
Repair Procedure,
How to Install the Generator
Pulley.
1 Align the woodruff key on the engine shaft
with the slot in the pulley bushing and slide
the pulley bushing onto the engine shaft. Do
not tighten the set screw.
2 Align the flywheel side of the pulley bushing
on the engine shaft with the outer face of the
generator pulley using a straightedge.
1 pulley shaft
2 pulley bushing
3 engine flywheel
4 straightedge
5 generator pulley
6 generator