Verint
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
91
EN.100.007-V4.8.C3.(1)
Verint
This section describes the additional configuration steps required for some Verint units to work
in Omnicast.
Configure S1808e-A and S1816e-A units
By default there are four Mic In audio inputs used in Omnicast, but S1808e-A and S1816e-A
units support up to eight Line In. For these units to use the Line In audio type, you must change
the input type in Omnicast.
1
In the
Physical View
in the Config Tool, select the unit to configure.
2
Expand the unit in the entity tree to view its attached devices.
3
Select the microphone to be configured.
4
From the
Input type
drop-down list in the
Properties
tab, select
Line In
.
5
Click
Apply
to save your changes.
6
For the new audio inputs to be available, restart the unit in Omnicast.
