Pelco
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
72
EN.100.007-V4.8.C3.(1)
Configuring Pelco Sarix units
Note the following when using Pelco Sarix units in Omnicast:
•
The video quality settings of the secondary stream are dependent on the primary stream.
The video settings of the second stream cannot be changed without first setting the primary
stream video settings to the desired values.
•
Motion detection settings depend on the resolution of the primary stream. If the resolution
is changed, the Archiver will re-send the motion detection settings to the unit.
•
Configuring the
Quality
setting in the camera’s Video Quality tab may have no effect on the
unit.
•
The greyed-out fields in the camera’s Video Quality tab (frame rate and resolution) may not
display the values configured on the unit.
•
The maximum frame rate available changes depending on the bit rate and the resolution set
in the Video Quality tab.
Naming Sarix Spectra HD PTZ preset tours
PTZ preset tours must be named “Endura X” using the unit’s Web page where X represents the
pattern number in Omnicast. For example, a tour named “Endura 1” in the unit’s Web page is
available as Pattern 1 in the Omnicast
Pattern
menu.
Configuring the CM9760-CC1 for use with the Pelco DMR protocol
The Pelco DMR protocol allows Omnicast to simulate eight simultaneous PTZ keyboards per
serial link for the CM9760-CC1 by emulating a CM9760-DMR. In order to use the Pelco DMR
protocol, the eight keyboard operators need unique pin numbers and the SERCOM connection
of the CM9760-CC1 needs to be set to “23 DMR-KBD”. You must also specify the first operator
pin number in Omnicast.
1
Open the CM9760-CC1 System Manager and access the System setup window.
