Mango DSP
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
56
EN.100.007-V4.8.C3.(1)
Configure input pin wiring
Input pins on Mango units work with a logical circuit value of 0/1. Omnicast closing and
opening events are mapped as follows:
•
To trigger an input pin closing event, the voltage on the pins should be dropped from
5 volts to 0 volts.
On Pegasus M units, the default value is 1. To change it to 0, short the pins.
•
To trigger an input pin opening event, the voltage on the pins should be raised from
0 volts to 5 volts.
On Condor VS-8 and VS-16 units, the default value is 0. To change it to 1, apply 5 volts on
the pins.
NOTE
The voltage mentioned is approximate, for the exact voltage range; please see the
documentation for your Mango DSP unit.
Configure input pin events on the standby Archiver
In order for input pin events to be received properly, only two Archivers can be associated with
Mango units, and the second Archiver requires a specific configuration:
1
On the second Archiver machine, navigate to the installation directory folder, located in:
C:\Program Files\Common Files\DVR Software 4.8\Extensions\Drivers
on 32-bit machines,
and
C:\Program Files (x86)\Common Files\DVR Software 4.8\Extensions\Drivers\
on 64-bit
machines.
2
Open the
MangoDspDriverConfiguration.xml
file in Notepad.
Text similar to the following is displayed:
<MangoDspDriverConfiguration>
<HttpServerPort>8080</HttpServerPort>
<HttpServerNumber>1</HttpServerNumber>
</MangoDspDriverConfiguration
3
Change the value of the
HttpServerNumber
from
1
to
2
.
NOTE
The
HttpServerPort
must be the same for both Archivers, and available to both
machines. Do not change the port number unless it is absolutely necessary.
4
Save the file, and restart the Archiver service.
