Basler
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
41
EN.100.007-V4.8.C3.(1)
6
To save your settings, close the
Streaming
section of the unit's Web page.
After you are done:
If the unit was already part of your Omnicast system, restart the unit to
apply your changes.
Configure the frame rate
For Basler units to stream at the exact frame rate set in Omnicast, you must configure the Expo-
sure Mode setting on the unit’s Web page.
1
Open the unit's Web page.
2
Click
Configuration > Camera Configuration > Image Controls
.
3
From the
Exposure Mode
drop-down list, select
Prioritize: Framerate
.
4
To apply your settings, close the
Image Controls
section of the unit’s Web page.
If you want the video streams to use a frame rate other than the values available in Omnicast,
you must also change the
Frame Rate Mode
setting in the unit’s Web page.
5
Click the
Camera Configuration > Streaming
tab.
6
Click the
Global
tab.
7
From the
Frame Rate Mode
drop-down list, select the desired frames per second value.
When you change the Global
Frame Rate Mode
setting, the frame rate values available in
Omnicast change. The values available in Omnicast are 1:1, 1:2, 1:4, and 1:8 of the Global
Frame Rate Mode
value.
After you are done:
If the unit was already part of your Omnicast system, restart the unit to
apply your changes.
