Genetec AutoVu SharpX Mobile, Руководство по оборудованию

Страница: 73 / 109

AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 67
Overview of aligning SharpX cameras
To ensure that your SharpX camera reads plates accurately, you must properly align it for your
specific deployment type.
Before you begin
Do the following:
• Determine which
alignment scenario applies to your situation.
• Make sure you have a SharpX Alignment Kit (AU-K-ALIGNKIT), with the following tools: tape
measure, plumb-bob weight, chalk, and a vertically adjustable target.
• Install and secure the SharpX .
• Make sure the camera is installed so that the camera roll is parallel to the ground:
A Level to ground (lens on the left).
B Not level to ground (body roll).
C Upside down (lens on the right).
• Have a laptop available to connect to the Sharp Portal, which displays the camera video feed that
you will use to validate alignment.
To align the SharpX:
1 Set up the tripod .
2 Attach the target to the tripod .
3 Align the SharpX with the target .
NOTE:
Do not tighten the securing screws for the pan/tilt. You will need to fine-tune the pan/tilt
angles to properly align the camera.